Limits have a requirement to complete an action when completing the job steps on the mobile app. Limits that can be selected in Builder and presented on the mobile app include:
- Recording a value or range of values for a particular unit of measure (UoM).
- Record text additional to a defect, note or hazard in a text box
- Feedback on acceptance of the task including a checkbox, pass/fail or selection of a condition from a user defined button list or value list.
- Taking a photo of the condition or validation.
- Recording multiple of the above via a table.
- Presenting a 3D image to display and rotate the graphical image for recording defects.
The following is a guide to how limits are presented on the app when selected in the builder. For MS Word document formats these are customised through the client specific output template.
BUILDER LIMIT OPTION | LIMIT DESCRIPTION | APP OUTPUT |
| None | No impact to App | |
| Checkbox | The Checkbox is displayed on the app. Tap the checkbox in the app to select. |  |
| Range | Select Range if a range of values need to be recorded on the output. The Unit of Measure drop down is displayed to allow a selection of measurement type i.e. mm, cm, psi, volts, etc. Enter the values in the app as required. |  |
| Value | Select Value if a single value needs to be recorded on the output. The Unit of Measure drop down is displayed to allow a selection of measurement type i.e. mm, cm, psi, kPa, etc. Enter the value in the app as required. |  |
| List (1-4) | Select List (1-4) if a predefined list is to be display. This list is client specific on the output and is typical a range of conditions to be recorded against the asset. Tap on the condition in the app to record the value |  |
| Table | Select Table to add a user defined table that has multiple criteria or requires values. NOTE: Results tables vary depending on the table created in Builder. Example results table  | |
| Pass/Fail | Select Pass/Fail if indication is required on the asset. The Limit Description should indicate what the given criteria is for the task. In the app, tap on the result. A Fail result will pop up the defect entry form. |  |
| Button List | Select Button List if value needs to be selected from a standard list. Custom button lists can be created and will appear as a selection. See article Adding a custom limits category |  |
| Dropdown List | Select Dropdown List if value needs to be selected from a standard list. Generally used is the list is large or has lots of text.. Custom lists can be created and will appear as a selection. See article Adding a custom limits category |  |
| Text Box | Select Textbox if text results are to be entered. |  |
| Structural Inspection | Select Structural Inspection if a 3D image is available to add to the inspection (Crack, Wear, Temperature, Leak, Other Defect). Use finger to rotate move the model around or pinch/expand two fingers to zoom in and out. |  |
| Photo | Select Photo if a photo needs to be captured as part of the job step. Tap the Add Photo button to access the device camera and take a photo. |  |
| Date | Select Date | |
| Signature | Select Signature if a physical signature is required. Tap the Sign button to access the signature box. Sign using a finger and tap Done when complete or Clear to resign. |   |
| QR / Barcode | ||