Record Results and Create Defects

Once a work order is tapped on, these guides take you through how to navigate and complete the job in the mobile application.

Record results in a table for a job step
The recording of results in the app is dependent on how information is added in the builder for the task. Refer to Builder to App Results Recording for more...
Thu, 24 Feb, 2022 at 10:35 AM
Record a Defect from a failed result
If a fail is entered when recording a result, the Add Defect pop-up is automatically displayed. Enter the following information: FIELDDESCRIPTIO...
Wed, 23 Feb, 2022 at 3:55 PM
Take a photo (limit) in a job step
You may be prompted to take a photo as part of a job step. Tap 
Thu, 24 Feb, 2022 at 11:21 AM
Add a Hazard
A Hazard can be added at any point when completing a job. Use the following steps to add a Hazard.
Thu, 24 Feb, 2022 at 2:44 PM
Add Feedback about a job step
Feedback can be added to each job step to provide information about the task.
Thu, 24 Feb, 2022 at 11:38 AM
Add a New Defect
A new defect can be created against any job step in the app. When adding a defect the user can provide information including Description of the defect is ...
Thu, 24 Feb, 2022 at 2:33 PM
Mark a job step incomplete
If a job step needs to be edited or was incorrectly completed. Tap on the job step that requires editing and mark as Incomplete as below.
Thu, 24 Feb, 2022 at 11:54 AM
Completing a Work Order (Job)
Once all steps in the job are complete, the work order can be completed. Review the Step Navigation Bar to ensure all job steps are complete. Once all s...
Thu, 24 Feb, 2022 at 1:03 PM